LED and Fiber Optic Lighting by Wiedamark

It's never been easier to add light and color to a pool or spa than with our LED Color Changing pool lamp. At the touch of a button, you can make your water dance with intense red, blue, green, opal, violet and golds - or just allow the lamp to gradually move from one beautiful color to another. Transform the mood as you enjoy dramatic dances of changing colors - a spectacular light show whether in or out of the water!

Click here to download our latest pool catalog.

How to change your LED Pool Lamp.

Shut off power at the breaker, and also at any other switches.
It is not necessary to lower the water level. Most all light fixtures have enough cord coiled up inside of the light niche to allow the fixture to be brought up onto the coping stone for repair. Remove the single stainless steel screw at the top of the light (at 12 o'clock). Once this is removed, use a flathead screwdriver to pry the fixture out of the niche. Most fixtures have a tab at the bottom (at 6 o'clock).
Remove the screws or clamp and gently pry the glass lens out of the front of the fixture.
After the lens is removed, remove the bulb and replace with the new LED lamp.
Before reassembly, turn on power Very Briefly (for 1-2 seconds) to check that the bulb/lamp is working.
Reassemble the lens onto the fixture, using a NEW lens gasket. This is the rubber gasket around the lens, approx 8" diameter. Make sure screws are very tight.
Place light under water and check for air leaks (a few bubbles may come off of the fixture ring). If you have no bubbles streaming out of your gasket, you have a good seal.
Replace the fixture into the niche. First coil the cord around the back of the fixture, then locate the bottom tab (on the fixture) and tab receiver (on the niche). Line them up and insert the tab into position, and push the fixture flush into the niche. Tighten screw down just snug (not too tight). Test your light again.
Patiently wait for the sun to go down and enjoy your spectacular new light show.