Telecontroller description:
5 key-presses as follows:
1. Key-press of the switch: red key in the center, switch on or switch off.
2. Color lighting: control the lamp into the
color lighting mode, press 3 seconds, it can control the lamp into the
color shading mode, the light can change the color automatically.
3. White lighting: control the lamp into the white lighting mode.
4. Turn up the light: it can control the
brightness increase of the lamp in any modes, it can increase one grade
after pressing one time, the total is 8 grades.
5. Turn down the light: it can control the
brightness reduction of the lamp in any modes, it can reduce one grade
after pressing one time, the total is 8 grades.
Color changing touch ring:
Touch ring is a highly reliable inductor, it can
reliably distinguish the location of the color ring, and only be
effective for human body and fingers. In the color mode, when the finger
touches the corresponding color, it will indicate the LED light to give
off the corresponding color. When it is in automatic demonstration
mode, the brightness adjusting can be used normally. If you exit or keep
the current color, you just need to press the color key-press, it will
exit automatic demonstration mode, and keep the current color.
Click to download an user manual.
Receiving Controller Parameters:
1. Case material: ABS + PC
2. Input Voltage: 1.5V 3 pcs AAA battery
3. Power consumption of the standby: max 100uA. Normally a set of new batteries can be used for 9-12 months;
4. Wireless frequency: 433.92MHz, all integration chips design, can pass the FCC certification;
5. Emission power: less than 10mW;
6. Mating telecontrol distance: open area 20-30m.
7. 12V or 24V Up to 180W